收藏切换
Experimental study on start-stop peak regulation of a 350 MW supercritical circulating fluidized bed coal-fired power unit
收藏切换
PDF
Haifeng SONG1, Junfeng WANG2, 3, 4, Zhonghong AN1, Wenxiang LAN1, Jian CHANG1, Jinliang GUO1, Liping LANG3, 4, Xiwei KE4, Junfu LYU2, 4
Thermal Power Generation | 2025, 54(7) : 63 - 70
Less
收藏切换
Thermal Power Generation | 2025, 54(7): 63-70
Special topic on “ultra supercritical circulating fluidized bed power generation technology”
Experimental study on start-stop peak regulation of a 350 MW supercritical circulating fluidized bed coal-fired power unit
Full
Haifeng SONG1, Junfeng WANG2, 3, 4, Zhonghong AN1, Wenxiang LAN1, Jian CHANG1, Jinliang GUO1, Liping LANG3, 4, Xiwei KE4, Junfu LYU2, 4
Affiliations
  • 1.Jinneng Holding Group Yanggao Thermal Power Co., Ltd., Datong 038100, China
  • 2.Department of Energy and Power Engineering, Tsinghua University, Beijing 100084, China
  • 3.Harbin Boiler Co., Ltd., Harbin 150046, China
  • 4.Shanxi Research Institute of Huairou Laboratory, Taiyuan 030032, China
Published: 2025-07-25 doi: 10.19666/j.rlfd.202503022
Outline
收藏切换

With the rapid expansion of new energy power generation capacity in China, the insufficient load regulation capability of coal-fired power plants has become increasingly evident. In order to explore the start-stop peak regulation capability of supercritical circulating fluidized bed (CFB) power units, a 350 MW supercritical CFB unit was taken as the research object, and experimental studies on banked-fire hot standby and rapid start-stop operations were conducted. The experimental results demonstrated that the supercritical CFB unit can rapidly reduce its load to near zero (with an average load change rate of about 10%Pe/min) during bank firing, and then maintain hot standby for 108 minutes. After banked firing, the boiler quickly switched to wet-state operation, with the main steam pressure decreasing rapidly at a rate of 0.13 MPa/min. By reasonably controlling the feedwater flow, the working fluid temperature and wall temperature of the water-cooled walls and water-cooled panels were kept stable. The heat released from the combustion of residual carbon caused the bed temperature to decrease slowly during banked firing, which also provided favorable conditions for re-ignition. During the load lift phase, the unit could be quickly started, with NOx emission mass concentration reaching an instantaneous peak of 101 mg/m3, while the hourly average was stable below 50 mg/m3. Throughout the entire experimental period, SO2 emission mass concentration was consistently below 35 mg/m3, and pollutant emissions met the ultra-low-emission requirements. All parameters of the steam turbine and generator remained within normal ranges during the hot standby and startup/shutdown. The rapid decline in main steam pressure and the low superheat of the main steam temperature were the main factors limiting the duration of banked firing in this experiment. The relevant research work provides a reference for the start-stop peak regulation of higher-parameter supercritical and ultra-supercritical CFB units.

supercritical  /  circulating fluidized bed boiler  /  peak regulation  /  banked fire for hot standby  /  fast start-stop
Haifeng SONG, Junfeng WANG, Zhonghong AN, Wenxiang LAN, Jian CHANG, Jinliang GUO, Liping LANG, Xiwei KE, Junfu LYU. Experimental study on start-stop peak regulation of a 350 MW supercritical circulating fluidized bed coal-fired power unit[J]. Thermal Power Generation, 2025 , 54 (7) : 63 -70 . DOI: 10.19666/j.rlfd.202503022
  • Young Elite Scientists Sponsorship Program of CAST(2024-2026QNRC001)
Year 2025 volume 54 Issue 7
PDF
133
58
Cite this Article
BibTeX
Article Info
doi: 10.19666/j.rlfd.202503022
  • Receive Date:2025-03-10
  • Online Date:2026-03-06
  • Published:2025-07-25
Article Data
Affiliations
History
  • Received:2025-03-10
Funding
Young Elite Scientists Sponsorship Program of CAST(2024-2026QNRC001)
Affiliations
    1.Jinneng Holding Group Yanggao Thermal Power Co., Ltd., Datong 038100, China
    2.Department of Energy and Power Engineering, Tsinghua University, Beijing 100084, China
    3.Harbin Boiler Co., Ltd., Harbin 150046, China
    4.Shanxi Research Institute of Huairou Laboratory, Taiyuan 030032, China
References
Share
https://castjournals.cast.org.cn/joweb/rlfd/EN/10.19666/j.rlfd.202503022
Share to
QR

Scan QR to access full text

Cite this article
BibTeX
Citations
表12种不同金属材料的力学参数

Family
属数
Number of
genus
种数
Number of
species
占总种数比例
Percentage of
total species (%)

Genus
种数
Number of
species
占总种数比例
Percentage of total
species (%)
鹅膏菌科Amanitaceae 2 11 5.26 鹅膏菌属 Amanita 10 4.78
小菇科 Mycenaceae 2 12 5.74 丝盖伞属 Inocybe 5 2.39
多孔菌科 Polyporaceae 8 14 6.70 蜡蘑属 Laccaria 5 2.39
红菇科 Russulaceae 3 23 11.00 小皮伞属 Marasmius 6 2.87
小菇属 Mycena 11 5.26
光柄菇属 Pluteus 5 2.39
红菇属 Russula 17 8.13
栓菌属 Trametes 5 2.39
关闭全屏
  • BibTeX
  • EndNote
  • RefWorks
  • TxT