PDF
Full
Outline
To investigate the effect of different cooling methods on the uniaxial compressive properties of ultra-high performance concrete (UHPC) after high temperature, 45 specimens with the dimension of 100 mm×100 mm×300 mm were designed and fabricated. The cooling methods and heating temperature were chosen as test variable parameters. Observe the apparent characteristics, quality loss, and failure mode were observed after different high temperatures and cooling methods. The variation law of compressive strength was analyzed. The experimental results show that as the temperature increases, the surface cracks increase. The mass loss rate increases under different cooling methods. A higher mass loss rate occurs under natural cooling with the same temperature. Under natural cooling, the mass loss rate increases rapidly at first and then slowly. An approximately linear increase is presented under water cooling. The compressive strength shows a trend of first slightly increasing and then decreasing. Compared with the normal temperature, with the temperature increase, the maximum compressive strength increased by 18.3% and 13.4% respectively under natural cooling and water cooling. When the temperature reaches 800 ℃, the compressive strength under natural cooling and water cooling decreases to 20.8% and 18.8% of compressive strength at normal temperature, respectively. When the temperature exceeds 600 ℃, the axial deformation ability of blocks is significantly enhanced. Compared with natural cooling, the peak strain under water cooling develops rapidly, but tends to be consistent at 800 ℃. The peak strain under natural cooling and water cooling increases to 2.22 times and 2.24 times the peak strain under normal temperature conditions, respectively. Compared with natural cooling, the elastic modulus under water cooling is relatively small and undergoes three stages: slow decrease, fast decrease, and slow decrease. Based on the experiments, a formula for calculating the residual strength of UHPC after water cooling is proposed, which can provide a basis for evaluating the load-bearing capacity of a building after fire.
PDF
137
64
| 科 Family | 属数 Number of genus | 种数 Number of species | 占总种数比例 Percentage of total species (%) | 属 Genus | 种数 Number of species | 占总种数比例 Percentage of total species (%) |
|---|---|---|---|---|---|---|
| 鹅膏菌科Amanitaceae | 2 | 11 | 5.26 | 鹅膏菌属 Amanita | 10 | 4.78 |
| 小菇科 Mycenaceae | 2 | 12 | 5.74 | 丝盖伞属 Inocybe | 5 | 2.39 |
| 多孔菌科 Polyporaceae | 8 | 14 | 6.70 | 蜡蘑属 Laccaria | 5 | 2.39 |
| 红菇科 Russulaceae | 3 | 23 | 11.00 | 小皮伞属 Marasmius | 6 | 2.87 |
| 小菇属 Mycena | 11 | 5.26 | ||||
| 光柄菇属 Pluteus | 5 | 2.39 | ||||
| 红菇属 Russula | 17 | 8.13 | ||||
| 栓菌属 Trametes | 5 | 2.39 |
关闭全屏
No. 86 Xueyuan South Road, Haidian District, Beijing
010-62199257
qkjq@cast.org.cn
Copyright © 2025 China Association for Science and Technology. All rights reserved. For all open access content, the relevant licensing terms apply.
Sponsored by the Office of the Leading Group for Cybersecurity and Informatization of CAST, and supported by Science and Technology Review Publishing House
