收藏切换
Study on the optimization of processing technology for green jujube pulp and its active ingredient and antioxidant activities
收藏切换
Hong ZHANG1, 2, Hui-Zhen LI1, 2, *, Jia ZHANG3, Zhen-Kui KANG3, Zhi-Jun ZHANG1, 2, Cai-Rong GUO1, 2, Pei-Rong NIU1, 2, Pei-Jun DUAN1, 2
Journal of Food Safety & Quality | 2026, 17(11) : 41 - 50
Less
收藏切换
Journal of Food Safety & Quality | 2026, 17(11): 41-50
• Highlight: Academic Paper Achievements of the 28th Annual Conference of the China Association for Science and Technology •
Study on the optimization of processing technology for green jujube pulp and its active ingredient and antioxidant activities
Full
Hong ZHANG1, 2, Hui-Zhen LI1, 2, *, Jia ZHANG3, Zhen-Kui KANG3, Zhi-Jun ZHANG1, 2, Cai-Rong GUO1, 2, Pei-Rong NIU1, 2, Pei-Jun DUAN1, 2
Affiliations
  • 1.School of Chemistry and Chemical Engineering, North University of China, Taiyuan 030051, China
  • 2.Shanxi Institute of Biotechnology for Great Health Industry, Taiyuan 030100, China
  • 3.Shanxi Tianjiaohong Biotechnology Co., Ltd., Lüliang 033000, China
doi: 10.19812/j.cnki.jfsq11-5956/ts.20260423005
Outline
收藏切换
Objective

To optimize the processing technology of green jujube pulp and investigate its change s in active substances and antioxidant activity.

Methods

Shanxi Banzao was used as the raw material, with direct pulping as the traditional process reference, and the effects of direct pulping, microwave-assisted pulping, and ultrasonic-assisted pulping on the flavonoids and polyphenols content in the pulp were compared to determine the optimal pulping method. A single-factor and orthogonal experimental design was employed to optimize the ultrasonic-enzymatic hydrolysis composite process, and the content of active components and antioxidant activity in the pulp were measured. Subsequently, the active component content and antioxidant properties of 9 kinds of Shanxi green jujube pulps were compared before and after process optimization, and high-quality varieties were selected through standardized relative value heat map analysis.

Results

Ultrasonic-assisted pulping significantly increased the polyphenol content in the pulp and was identified as the optimal method. The optimized ultrasonic-enzymatic hydrolysis parameters were determined as follows: Ultrasonic power 450 W, feed-to-pulp ratio 1:20 (m:V), and enzyme addition rate 0.7%. Under these conditions, the total flavonoid content in Banzao pulp reached 392.46±5.43 mg/100 g, while the half maximal inhibitory concentration values for 1,1-diphenyl-2-picrylhydrazyl (DPPH) and 2,2’-azino-bis(3-ethylbenzothiazoline-6-sulfonic acid (ABTS+) scavenging capacities were as low as 4.51 mg/mL and 15.9 mg/mL, respectively. The total vitamin C and dietary fiber contents increased by 25.2% and 0.8%, respectively.Heat map analysis identified 3 green jujube varieties-Banzao, Youzao and Tuntun-as those with the highest overall quality.

Conclusion

This study optimized and established the optimal production process for green jujub pulp, and the content of its active ingredients and antioxidant activity are effectively enhanced. The findings provide theoretical support for optimizing the processing techniques and selecting suitable varieties of green jujube pulps, which demonstrate significant practical value and potential for widespread application.

green jujube  /  flavonoids  /  polyphenols  /  vitamin C  /  dietary fiber  /  antioxidant activity  /  process optimization
张宏, 李会珍, 张嘉, 康振奎, 张志军, 郭彩蓉, 牛培蓉, 段佩君. 青枣果浆加工工艺优化及其活性成分与抗氧化活性研究. 食品安全质量检测学报, 2026 , 17 (11) : 41 -50 . DOI: 10.19812/j.cnki.jfsq11-5956/ts.20260423005
Hong ZHANG, Hui-Zhen LI, Jia ZHANG, Zhen-Kui KANG, Zhi-Jun ZHANG, Cai-Rong GUO, Pei-Rong NIU, Pei-Jun DUAN. Study on the optimization of processing technology for green jujube pulp and its active ingredient and antioxidant activities[J]. Journal of Food Safety & Quality, 2026 , 17 (11) : 41 -50 . DOI: 10.19812/j.cnki.jfsq11-5956/ts.20260423005
Year 2026 volume 17 Issue 11
5
0
Cite this Article
BibTeX
Article Info
doi: 10.19812/j.cnki.jfsq11-5956/ts.20260423005
  • Receive Date:2026-04-23
  • Online Date:2026-11-05
Article Data
Affiliations
History
  • Received:2026-04-23
Funding
Affiliations
    1.School of Chemistry and Chemical Engineering, North University of China, Taiyuan 030051, China
    2.Shanxi Institute of Biotechnology for Great Health Industry, Taiyuan 030100, China
    3.Shanxi Tianjiaohong Biotechnology Co., Ltd., Lüliang 033000, China
References
Share
https://castjournals.cast.org.cn/joweb/spaq/EN/10.19812/j.cnki.jfsq11-5956/ts.20260423005
Share to
QR

Scan QR to access full text

Cite this article
BibTeX
Citations
表12种不同金属材料的力学参数
科
Family
属数
Number of
genus
种数
Number of
species
占总种数比例
Percentage of
total species (%)
属
Genus
种数
Number of
species
占总种数比例
Percentage of total
species (%)
鹅膏菌科Amanitaceae 2 11 5.26 鹅膏菌属 Amanita 10 4.78
小菇科 Mycenaceae 2 12 5.74 丝盖伞属 Inocybe 5 2.39
多孔菌科 Polyporaceae 8 14 6.70 蜡蘑属 Laccaria 5 2.39
红菇科 Russulaceae 3 23 11.00 小皮伞属 Marasmius 6 2.87
小菇属 Mycena 11 5.26
光柄菇属 Pluteus 5 2.39
红菇属 Russula 17 8.13
栓菌属 Trametes 5 2.39
关闭全屏
  • BibTeX
  • EndNote
  • RefWorks
  • TxT