收藏切换
Preparation and Properties of Al-Pillared Montmorillonite/Carbon Nanocomposites
收藏切换
Xueping WU1, 2, Qing HE1, Jiarui YU1, Taohou YU1, Xianlong ZHANG1
Journal of the Chinese Ceramic Society | 2023, 51(12) : 3121 - 3132
Less
收藏切换
Journal of the Chinese Ceramic Society | 2023, 51(12): 3121-3132
• Research Articles •
Preparation and Properties of Al-Pillared Montmorillonite/Carbon Nanocomposites
Full
Xueping WU1, 2, Qing HE1, Jiarui YU1, Taohou YU1, Xianlong ZHANG1
Affiliations
  • 1.School of Chemistry and Chemical Engineering, Hefei University of Technology, Hefei 230009, China
  • 2.Engineering Research Center of Advanced Composite Materials Design & Application of Anhui Province, Hefei 230009, China
  • WU Xueping (1978-), female, Ph.D., Professor. E-mail:

About Author:

WU Xueping (1978-), female, Ph.D., Professor. E-mail:

Published: 2023-09-12 doi: 10.14062/j.issn.0454-5648.20230489
Outline
收藏切换

Al-pillared montmorillonite/carbon nanocomposites were prepared by a hydrothermal method using Al-pillared montmorillonite as a template and chitosan as a carbon source, and then hot-pressed to obtain Al-pillared montmorillonite-based ceramic/carbon composites. The effect of carbon content on the densities, mechanics, electrical conductivity and wave absorption properties of the composites was investigated by X-ray diffraction, scanning electron microscopy, universal material tests and vector network analysis. The results show that the Al-pillared montmorillonite/carbon is transformed into mullite/carbon ceramic material by hot-press sintering, and the carbon is further graphitized in the hot pressing. The introduction of carbon enhances the electrical conductivity and toughness of the composites, while a large amount of interfacial polarization is formed inside the material, which enhances the dielectric loss of the composites and transforms the ceramic material from a wave-transparent body to an electromagnetic wave absorbing material. The internal microcracks of the composites increase and the flexural strength gradually decreases with the further increase of carbon mass fraction in aluminum column-supported montmorillonite. The fracture toughness of the composite material is the maximum value when the mass ratio of montmorillonite to chitosan is 32 at 1 300 ℃, 20 MPa and 120 min of holding time, which is 11.41% greater than that of ceramics without carbon addition. The maximum electrical conductivity of the composite material is 17.53 S·m-1 when the mass ratio of montmorillonite to chitosan is 4. According to the simulation calculations through wave absorption performance tests, the minimum RL value of the obtained material reaches -44.93 dB when the coating thickness is 1.4 mm. The minimum RL value is -36.28 dB and the effective absorption bandwidth is 5.0 GHz when the coating thickness is 1.6 mm.

alminum-pillared montmorillonite  /  chitosan  /  ceramic/carbon  /  mechanical properties  /  microwave absorbing property
吴雪平, 何青, 俞嘉睿, 余涛厚, 张先龙. 铝柱撑蒙脱石基陶瓷/碳复合材料的制备及其性能. 硅酸盐学报, 2023 , 51 (12) : 3121 -3132 . DOI: 10.14062/j.issn.0454-5648.20230489
Xueping WU, Qing HE, Jiarui YU, Taohou YU, Xianlong ZHANG. Preparation and Properties of Al-Pillared Montmorillonite/Carbon Nanocomposites[J]. Journal of the Chinese Ceramic Society, 2023 , 51 (12) : 3121 -3132 . DOI: 10.14062/j.issn.0454-5648.20230489
Year 2023 volume 51 Issue 12
56
5
Cite this Article
BibTeX
Article Info
doi: 10.14062/j.issn.0454-5648.20230489
  • Receive Date:2023-07-11
  • Online Date:2026-10-19
  • Published:2023-09-12
Article Data
Affiliations
History
  • Received:2023-07-11
  • Revised:2023-07-29
Funding
Affiliations
    1.School of Chemistry and Chemical Engineering, Hefei University of Technology, Hefei 230009, China
    2.Engineering Research Center of Advanced Composite Materials Design & Application of Anhui Province, Hefei 230009, China

Corresponding:

ZHANG Xianlong (1978-), male, Ph.D., Associate Professor. E-mail:
References
Share
https://castjournals.cast.org.cn/joweb/gsyxb/EN/10.14062/j.issn.0454-5648.20230489
Share to
QR

Scan QR to access full text

Cite this article
BibTeX
Citations
表12种不同金属材料的力学参数
科
Family
属数
Number of
genus
种数
Number of
species
占总种数比例
Percentage of
total species (%)
属
Genus
种数
Number of
species
占总种数比例
Percentage of total
species (%)
鹅膏菌科Amanitaceae 2 11 5.26 鹅膏菌属 Amanita 10 4.78
小菇科 Mycenaceae 2 12 5.74 丝盖伞属 Inocybe 5 2.39
多孔菌科 Polyporaceae 8 14 6.70 蜡蘑属 Laccaria 5 2.39
红菇科 Russulaceae 3 23 11.00 小皮伞属 Marasmius 6 2.87
小菇属 Mycena 11 5.26
光柄菇属 Pluteus 5 2.39
红菇属 Russula 17 8.13
栓菌属 Trametes 5 2.39
关闭全屏
  • BibTeX
  • EndNote
  • RefWorks
  • TxT