Home Latest Articles
Latest Articles
  • Xinyu WU, Yubin LIU, Hong YAN, Kuaile LIN, Weicheng ZHOU
    Chinese Journal of Pharmaceuticals. 2024, 55(8): 1085-1088.

    1,2-Dipalmitoyl-sn-glycero-3-phosphorylcholine(DPPC, 1) can be used not only as a pharmaceutical excipient, but also as an exogenous lung surfactant for the treatment of neonatal respiratory distress syndrome(NRDS). Glycerophosphatidylcholine(GPC, 2) reacted with palmitic acid(PA, 3) in the presence of 4-dimethylaminopyridine(DMAP) and dicyclohexylcarbodiimide(DCC) in DCM to yield 1. But it was found that an impurity was produced, which seriously affected the purification of the product. After isolation and purification, the impurity was confirmed by MS and 1H NMR to be 1,1'-methylene-bis(4-dimethylaminopyridinium) dichloride. Through replacing reaction solvent to acetonitrile and reducing the feeding molar ratio of DMAP from 3 to 1, the yield of the target product 1 was increased from 33.20% to 49.18% with purity of 99.92%.

  • Kang YANG, Qun ZHENG, Weiting WU, Xuxiang CHEN, Jianhong ZHAO
    Chinese Journal of Pharmaceuticals. 2024, 55(8): 1089-1092.

    Using fluorene(2) as the starting material, it was chlorinated by trichloroisocyanuric acid to obtain 2,7-dichlorofluorene(3), which was acylated with chloroacetyl chloride to produce 2,7-dichlorofluorene-4-chloroethyl ketone(4). Then, α-(di-n-butylaminomethyl)-2,7-dichloro-4-fluorenylmethanol(5) was obtained via reduction, cyclization and amination by one-pot method. Finally, 5 was condensed with p-chlorobenzaldehyde to obtain benfluorenol(1), with an overall yield of 36% and a purity of 99.4%. The improved process used trichloroisocyanuric acid as the chlorinating agent, which improved the selectivity and safety of the reaction. The reduction, cyclization and amination were completed by one-pot method, which reduced the reaction temperature, shortened the reaction cycle, improved production efficiency, and increased the yield from 60% to 80%. The improved process was simple to operate, low in production cost and suitable for industrial production.

  • Ru LI, Ming WANG, Sheng LIU
    Chinese Journal of Pharmaceuticals. 2024, 55(8): 1093-1097.

    Four potential related substances were synthesized, namely 2-[(7R,11R)-2,3-dihydroxy-3,7,11,15-tetramethylhexadecyl]-3-methylnaphthalene-1,4-dione(related substance A), 1α-methyl-7α-[(7R,11R,E)-3,7,11,15-tetramethylhexadec-2-en-1-yl]-1α,7α-dihydronaphtho[2,3-b]oxirene-2,7-dione(related substance B), 2-[(7R,11R,E)-3-hydroxy-3,7,11,15-tetramethylhexadec-1-en-1-yl]-3-methylnaphthalene-1,4-dione(related substance C) and 2,5-dimethyl-2-[(4R,8R)-4,8,12-trimethyltridecyl]-2H-benzo[h]chromen-6-ol(related substance D). Their structures were confirmed by 1H NMR and MS, which provided a reference for the quality control of vitamin K1.

  • Erjun HAO, Yan ZHAO, Ruping JIA, Yuman SONG, Yangbo CUI, Tong LI, Binghui LU
    Chinese Journal of Pharmaceuticals. 2024, 55(8): 1098-1099.

    An improved synthetic process of fludarabine phosphate(1) was developed. Commercially available fludarabine was subjected to a nucleophilic substitution with triethyl phosphate. Subsequently, the target compound 1 was obtained through hydrolysis of triethyl phosphate on exposure to phosphorus oxychloride condition with an overall yield of 81% and a purity of 99.91%. The optimized process bearing mild reaction conditions, simple operation and stable process had been tested by process verification, and was suitable for industrial production.

  • Ying TONG, Wenbo LI
    Chinese Journal of Pharmaceuticals. 2024, 55(8): 1100-1106.

    The droplet size distribution was measured by the laser particle size measurement system, while the spray pattern and plume geometry were measured by SprayVIEW laser imaging system. The spray performances of two kinds of suspension nasal sprays between the original drugs and the generic drugs were compared. Additionally, the consistency of spray performances between different batches of the samples from 4 companies(A, B, C, D) was analyzed in this study. The results showed that d(0.5) was in the range of 27 - 51 μm. The droplet size distribution results of the products from companies A and B, C and D were different. The intra- and inter-batch variabilities of the droplet size distribution of nasal sprays from companies A and D were less than those of the products from companies B and C, respectively. The spray area showed a significant difference between the original drugs and the generic drugs. The plume geometry results of the products from companies A and B, C and D were similar. The cross section of the spray was nearly circular with elliptical rate of 1.13 to 1.41. The spray performance results of the products from the original drugs and the generic drugs were different. Therefore, it was necessary to strengthen the investigation on detection methods of the spray performances and comparison study of different products in the development of nasal spray products.

  • Yaru ZUO, Xian YANG, Haiting HOU, Fanghong ZHAO, Xiaoyang MA, Lijie SUN
    Chinese Journal of Pharmaceuticals. 2024, 55(8): 1107-1113.

    The LC-MS/MS method was established to determine salbutamol sulfate in rat tracheobronchial and lung tissues. The results showed that the linear ranges in tracheobronchial and lung tissues were 10.41 - 10 410 and 5.205 –5 205 ng/g, respectively. The intra- and inter-day RSDs of the samples from different tissues were less than 15%. After inhalation administration, salbutamol sulfate showed similar dynamic changes in the tracheobronchial and lung tissues of rats, and reached maximum concentration immediately after administration, followed by rapid elimination. The inhalation of salbutamol sulfate solution was widely distributed in the tracheal and bronchus of the target site, which provided a reference basis for the clinical use.

  • Jihong LU, Shanshan FAN, Qiang WANG, Xiangkui LIU, Yuhui SHEN
    Chinese Journal of Pharmaceuticals. 2024, 55(8): 1114-1120.

    Drug co-crystal had a promising application in improving the solubility and dissolution of poorly water-soluble drugs. The compound sulfamethoxazole tablets contain two active pharmaceutical ingredients: sulfamethoxazole and trimethoprim, which may form co-crystal. In this paper, the existence of the co-crystal in the tablets had been confirmed by comparison with the standard samples. Then, three influence factors introduced in the formulation process, namely water content, pressure and temperature, on the formation of sulfamethoxazole-trimethoprim co-crystal was investigated. The results showed that water content was the key parameter for the formation of the co-crystal, whereas the co-crystal was formed only when the temperature reached above 128 ℃. Pressure was proved to have no effect on the formation of the co-crystal. The formed co-crystal had a stable crystal structure, which improved the compression resistance of the tablets.

  • Wenqing DENG, Shen ZHANG, Qingqing WANG, Yingzi WU
    Chinese Journal of Pharmaceuticals. 2024, 55(8): 1121-1128.

    A dye ingress method was established to assess the package integrity of prefilled syringes and vials. On the basis of setting rational parameters as well as preparing negative and positive samples, the vacuum, negative pressure holding time and the processing method of the prefilled syringe packaging system were optimized, and the method was verified. The results showed that the sensitivity of this method for assessment the integrity of the prefilled syringe packaging system and the vial packaging system was 10 - 15 μm, and was better than those in the USP, EP and International Organization for Standardization under the same conditions. This method could effectively assess the integrity of the prefilled syringe packaging system and the vial packaging system, which provided a reference for establishing the test standard for the prefilled syringe packaging system and the vial packaging system by dye ingress method.

  • Jing PAN, Xinru YANG, Tiejian LI, Zhongli HAN, Guimin ZHANG
    Chinese Journal of Pharmaceuticals. 2024, 55(8): 1129-1134.

    An pre-column derivatization HPLC method with dithiodipropionic acid(DTDPA) and o-phthalaldehyde(OPA) was established to determine the amino acid ratios in plecanatide. The results showed that the quantitative limits were 0.006 9 - 0.012 7 μmol/mL, the detection limits were 0.003 5 - 0.006 3 μmol/mL. The linearity and solution stability of all amino acids were good with minimum r of 0.999 6 and the maximum RSD(n=9) of 4.058%. The precision was good with the maximum RSD(n=12) of 2.41%. The mean recoveries(n=9) were 97.32% - 101.96%, the maximum RSD was 1.22%. In case of detection parameters slight change, the durability was good with the maximum RSD(n=16) of 1.61%. The established method is specific, accurate and efficient, which can be used for determination of the amino acid ratios of plecanatide.

  • Yifei CHEN, Linsha MA, Fen LIU
    Chinese Journal of Pharmaceuticals. 2024, 55(8): 1136-1142.

    At present, recombinant adeno-associated virus is the most commonly used vectors for in vivo gene therapy products. For producing virus vectors, plasmids are believed to be the important starting raw material. The designing and managing of plasmids directly contribute to the biological mechanisms, pharmaceutical properties, efficacy, and safety of products. Therefore, understanding the properties of plasmids and their gene elements is the basis for the “quality by design” of such products. The functions of different plasmids are introduced in this paper, the construction of main genetic elements are summarized, the considerations for designing of plasmids are discussed, the compliance for developing and manufacturing of plasmids are reviewed, in order to provide some references for the development and management of gene therapy products, especially for the recombinant adeno-associated virus products.

News