doi: 10.7501/j.issn.0253-2670.2025.13.008
Objective To optimize the comprehensive properties of Gegen Qinlian Compound (GQC, 葛根芩连方) extract powder using surface modification technology, screen the best modifier and process, and provide guidance for formulation development. Methods The ball mill (BM) and spray drying (SD) coating modification techniques were used, and three modifiers, silicon dioxide (SiO2), ethyl cellulose (EC) and magnesium stearate (ST), were selected. The GQC modified extract powders were prepared and designated GQC/BM-SiO2, GQC/BM-EC, GQC/BM-ST and GQC/SD-SiO2, GQC/SD-EC, GQC/SD-ST. All powders were measured secondary indicators, including H, HR, α, Da, Dc, IH, IC, Ie, D50, span, width and SSA, draw physical fingerprints, and conduct similarity analysis. Convert the secondary indicators into 5 primary indicators, determine the weights using the entropy weight coefficient of variation method, calculate the comprehensive performance score, screen for the optimal solution, and observe the changes in particle surface morphology and structure using scanning electron microscopy (SEM). Principal component analysis (PCA) evaluates the contribution rate of secondary indicators, while partial least squares analysis (PLSA) analyzes the correlation between key indicators H and SSA. Results GQC and six groups of modified powders (GQC/BM-SiO2, GQC/BM-EC, GQC/BM-ST and GQC/SD-SiO2, GQC/SD-EC, GQC/SD-ST) were obtained, and physical fingerprints were drawn and similarity was calculated. The similarity between GQC extract powder and GQC/BM-SiO2, GQC/BM-ST, GQC/BM-EC were 0.953, 0.920, and 0.969 respectively, indicating negligible modification, GQC extract powder compared with GQC/SD-SiO2, GQC/SD-ST, QC/SD-EC the similarity were 0.477, 0.449, and 0.439, respectively, indicating significant modification effect. The weight coefficients of the first level indicators are: liquidity 0.104 8, accumulation 0.134 1, compressibility 0.111 0, stability 0.133 1, and uniformity 0.517 0. The comprehensive score of magnesium stearate modifier in the BM group was the highest at 50.54, an increase of 18.92%. The mean value was 62.65 an increase of 47.41%, After SD modification, the best modification effect of GQC/SD-ST was 63.21. SEM shows that ST uniformly coats the surface of the extract powder, with smooth particle surfaces, uniform sizes, and high roundness. PCA analysis shows that IH, D50, span, width, and SSA contribute significantly. PLSA analysis showed a significant correlation between H and α, IC, width, IH, D50, span, SSA, which were related to powder density, SSA is significantly associated with D50, width, and span, with particle size and span having the greatest impact. Conclusion Surface modification technology can improve the comprehensive performance of GQC extract powder. SD modification has a better effect, and ST modifier has the highest score, providing reference for formulation development.