收藏切换
Analysis of structural plane stability in the Panlong lead–zinc mine, Guangxi, China and its engineering implications
收藏切换
Xiaopan HUANG1, Chenghu WANG1, *, Chengwei YANG1, Jikun LIU1, 2, Haifan XIAO1
Journal of Geomechanics | 2026, 32(2) : 439 - 451
Less
收藏切换
Journal of Geomechanics | 2026, 32(2): 439-451
• Crustal Stress & Tectonic Stress Field •
Analysis of structural plane stability in the Panlong lead–zinc mine, Guangxi, China and its engineering implications
Full
Xiaopan HUANG1, Chenghu WANG1, *, Chengwei YANG1, Jikun LIU1, 2, Haifan XIAO1
Affiliations
  • 1National Institute of Natural Hazards, Ministry of Emergency Management, Beijing 100085, China
  • 2School of Engineering and Technology, China University of Geosciences (Beijing), Beijing 100083, China
Published: 2026-04-28 doi: 10.12090/j.issn.1006-6616.2025083
Outline
收藏切换
Objective

The Panlong lead–zinc mine, an important polymetallic mine in central Guangxi, faces increasing challenges related to high in-situ stress and structurally complex rock masses as mining progresses to greater depths. Instabilities along structural planes have become a major geotechnical hazard. However, current understanding of the interplay between fracture geometry and the stress field remains limited. This study aims to evaluate the stability of structural planes at depth and their implications for safe mine development.

Methods

High-resolution data on fracture orientation and spacing were obtained through ultrasonic borehole television imaging in boreholes SK1 and SK2. Hydraulic fracturing tests were used to determine the magnitude and orientation of in-situ stresses. Stress tensor transformation and the Coulomb friction criterion were applied to estimate shear and normal stresses on structural planes and to assess their slip tendency under current stress conditions.

Results

The rock mass in the Panlong mine contains steeply dipping structural planes predominantly oriented NW–NNW and NE–NEE. Cluster analysis revealed three dominant fracture sets, reflecting tectonic control from nearby faults. Furthermore, in-situ stress measurements between 500 and 850 m depth show SH = 28.29−44.69 MPa, Sh = 19.46−27.09 MPa, and Sv = 14.50−22.68 MPa. The average values of the maximum and minimum horizontal lateral pressure coefficients are kH=2.07 and kh=1.28, respectively, indicating a horizontal compressive regime with SH oriented NW–NNW. Analysis of borehole breakouts and drilling-induced fractures supports the NW–NNW orientation of maximum horizontal stress. Subsequently, a total of 2,948 structural planes were analyzed. Slip tendency evaluation based on slip tendency (Ts = 0.2−0.4) shows that fractures with Ts > 0.20 are primarily distributed at depths less than 550 m. Steeper fracture planes (40°−75°) exhibit a high slip potential, indicating a higher likelihood of shear slip. NW–NNW-oriented planes exhibit both high density and high slip potential, especially when fracture aperture exceeds 10 mm.

Conclusions

The structural planes in the Panlong mine are characterized by steep dips and strong orientation clustering, primarily NW–NNW and NE–NEE, reflecting significant tectonic control. The in-situ stress regime is governed by horizontal compression, which favors the activation of reverse faults. This aligns with observed fracture development and supports the role of tectonic faults in stress field evolution. NW–NNW-oriented fractures, particularly those with low slip tendency and wide apertures, pose the highest risk for shear reactivation under current conditions and require targeted monitoring and support. Furthermore, structural planes in shallow zones (<550 m) present a higher slip potential than those in deeper zones, emphasizing the need for depth-specific design strategies. [Significance] These findings provide a detailed understanding of structural plane behavior under deep mining conditions and offer scientific support for roadway layout optimization, support system design, and hazard mitigation.

Panlong lead-zinc mine  /  borehole TV  /  hydraulic fracturing  /  rock structural plane  /  stress field  /  structural plane stability
黄晓盼, 王成虎, 杨承伟, 刘冀昆, 肖海帆. 盘龙铅锌矿结构面稳定性分析及其工程意义研究. 地质力学学报, 2026 , 32 (2) : 439 -451 . DOI: 10.12090/j.issn.1006-6616.2025083
Xiaopan HUANG, Chenghu WANG, Chengwei YANG, Jikun LIU, Haifan XIAO. Analysis of structural plane stability in the Panlong lead–zinc mine, Guangxi, China and its engineering implications[J]. Journal of Geomechanics, 2026 , 32 (2) : 439 -451 . DOI: 10.12090/j.issn.1006-6616.2025083
  • This research was financially supported by the National Natural Science Foundation of China (Grant No. 42174118).
Year 2026 volume 32 Issue 2
29
12
Cite this Article
BibTeX
Article Info
doi: 10.12090/j.issn.1006-6616.2025083
  • Receive Date:2025-07-08
  • Online Date:2026-11-17
  • Published:2026-04-28
Article Data
Affiliations
History
  • Received:2025-07-08
  • Revised:2025-09-07
  • Accepted:2025-09-10
Funding
This research was financially supported by the National Natural Science Foundation of China (Grant No. 42174118).
Affiliations
    1National Institute of Natural Hazards, Ministry of Emergency Management, Beijing 100085, China
    2School of Engineering and Technology, China University of Geosciences (Beijing), Beijing 100083, China
References
Share
https://castjournals.cast.org.cn/joweb/dzlxxb/EN/10.12090/j.issn.1006-6616.2025083
Share to
QR

Scan QR to access full text

Cite this article
BibTeX
Citations
表12种不同金属材料的力学参数
科
Family
属数
Number of
genus
种数
Number of
species
占总种数比例
Percentage of
total species (%)
属
Genus
种数
Number of
species
占总种数比例
Percentage of total
species (%)
鹅膏菌科Amanitaceae 2 11 5.26 鹅膏菌属 Amanita 10 4.78
小菇科 Mycenaceae 2 12 5.74 丝盖伞属 Inocybe 5 2.39
多孔菌科 Polyporaceae 8 14 6.70 蜡蘑属 Laccaria 5 2.39
红菇科 Russulaceae 3 23 11.00 小皮伞属 Marasmius 6 2.87
小菇属 Mycena 11 5.26
光柄菇属 Pluteus 5 2.39
红菇属 Russula 17 8.13
栓菌属 Trametes 5 2.39
关闭全屏
  • BibTeX
  • EndNote
  • RefWorks
  • TxT