收藏切换
Study on creep characteristics of fractured rock masses in caved zones with different roof strengths
收藏切换
Guanjun CAI1, Qiong WU1, Yunrong LIU2, Yidan LI2
Journal of Geomechanics | 2025, 31(4) : 657 - 672
Less
收藏切换
Journal of Geomechanics | 2025, 31(4): 657-672
• Crustal Stress & Tectonic Stress Field •
Study on creep characteristics of fractured rock masses in caved zones with different roof strengths
Full
Guanjun CAI1, Qiong WU1, Yunrong LIU2, Yidan LI2
Affiliations
  • 1Beijing Jingneng Geological Engineering Co., LTD., Beijing 102300, China
  • 2School of Engineering and Technology, China University of Geosciences (Beijing), Beijing 100083, China
Published: 2025-08-28 doi: 10.12090/j.issn.1006-6616.2024135
Outline
收藏切换
Objective

The caved zone in goaf areas is filled with fractured rock masses, and the strength of these fractured rock masses after collapse serves as a key factor causing differential long-term creep characteristics of the goaf. This study aims to comprehensively explore the creep characteristics of fractured rock masses with varying strengths.

Method

Grounded in the similarity theory, we selected analogous models of fractured rock masses representing three strength categories: soft rock, moderately hard rock, and hard rock. By integrating indoor step-loading creep tests with theoretical analysis, a systematic comparison of creep characteristics of fractured rock masses with varying strengths was carried out.

Results

The creep test results of three types of fractured rock masses reveal distinct deformation characteristics. Soft rock masses exhibit “sudden axial strain increments” under loads of 3 kN and 4 kN, while moderately hard rock masses display this phenomenon under a broader range of 3–5 kN. Evolution patterns of instantaneous, creep, and total strains show marked differences as the creep stress increases: soft rock masses demonstrate progressive decreases before stabilizing (instantaneous strain dropping from 0.084% at 1 kN to stable values beyond 4 kN); moderately hard rock masses exhibit an initial increase followed by subsequent decrease with peak strains occurring at different stresses (instantaneous at 2 kN, creep at 3 kN, total at 2 kN); and hard rock masses present more complex characteristics with instantaneous strain initially declining (0.033% to 0.020% in the 1–3 kN range) before rebounding slightly, while creep strain shows a triphasic pattern (increase–decrease–increase) peaking at 0.009% (3 kN) and total strain exhibits an overall trend of initial decrease followed by subsequent increase. Notably, all rock types share decreasing initial and steady-state creep rates with increasing stress. Compared with soft and hard rock masses, moderately hard rock masses experience more significant particle breakage and rearrangement during the creep process. This leads to an initial peak creep rate of 0.176 h−1 at 2 kN, exhibiting distinct peak characteristics. In contrast, hard rock masses exhibit rapid decay in creep rate and quick stabilization, reflecting their dense internal structure and strong interparticle contacts. These characteristics endow hard rock masses with rapid and stable mechanical response properties during the load-bearing process. The response differences of rock masses with varying strengths under the same load show positive correlation between rock strength and initial creep rate but an inverse relationship with steady-state rate. This indicates that while high-strength rocks respond more vigorously initially, they stabilize faster than low-strength rocks which sustain a longer duration of deformation.

Conclusion

Under incremenal loading, all three types of fractured rock masses exhibit decreasing trends in both initial and steady-state creep rates with increasing load, with particularly pronounced creep rate variations in the initial stage.

Significance

This study reveals creep characteristics of fractured rock masses of varying strength, providing a theoretical foundation for predicting long-term deformation of caved zones in goaf areas and developing geohazard prevention and control strategies.

different strength  /  fractured rock mass  /  similar materials  /  creep characteristics
蔡冠军, 吴琼, 刘运荣, 李一丹. 不同顶板强度垮落带破碎岩体蠕变特性研究. 地质力学学报, 2025 , 31 (4) : 657 -672 . DOI: 10.12090/j.issn.1006-6616.2024135
Guanjun CAI, Qiong WU, Yunrong LIU, Yidan LI. Study on creep characteristics of fractured rock masses in caved zones with different roof strengths[J]. Journal of Geomechanics, 2025 , 31 (4) : 657 -672 . DOI: 10.12090/j.issn.1006-6616.2024135
Year 2025 volume 31 Issue 4
52
22
Cite this Article
BibTeX
Article Info
doi: 10.12090/j.issn.1006-6616.2024135
  • Receive Date:2025-03-05
  • Online Date:2026-11-13
  • Published:2025-08-28
Article Data
Affiliations
History
  • Received:2025-03-05
  • Revised:2025-06-06
  • Accepted:2025-06-11
Affiliations
    1Beijing Jingneng Geological Engineering Co., LTD., Beijing 102300, China
    2School of Engineering and Technology, China University of Geosciences (Beijing), Beijing 100083, China
References
Share
https://castjournals.cast.org.cn/joweb/dzlxxb/EN/10.12090/j.issn.1006-6616.2024135
Share to
QR

Scan QR to access full text

Cite this article
BibTeX
Citations
表12种不同金属材料的力学参数
科
Family
属数
Number of
genus
种数
Number of
species
占总种数比例
Percentage of
total species (%)
属
Genus
种数
Number of
species
占总种数比例
Percentage of total
species (%)
鹅膏菌科Amanitaceae 2 11 5.26 鹅膏菌属 Amanita 10 4.78
小菇科 Mycenaceae 2 12 5.74 丝盖伞属 Inocybe 5 2.39
多孔菌科 Polyporaceae 8 14 6.70 蜡蘑属 Laccaria 5 2.39
红菇科 Russulaceae 3 23 11.00 小皮伞属 Marasmius 6 2.87
小菇属 Mycena 11 5.26
光柄菇属 Pluteus 5 2.39
红菇属 Russula 17 8.13
栓菌属 Trametes 5 2.39
关闭全屏
  • BibTeX
  • EndNote
  • RefWorks
  • TxT