收藏切换
Water inrush mechanism and the minimum safety thickness of the rock wall of a tunnel crossing a fault fracture zone
收藏切换
Dong YUAN1, 2, Kun XIAO1
Journal of Geomechanics | 2025, 31(1) : 80 - 90
Less
收藏切换
Journal of Geomechanics | 2025, 31(1): 80-90
• Geo-hazards & Engineering Geology •
Water inrush mechanism and the minimum safety thickness of the rock wall of a tunnel crossing a fault fracture zone
Full
Dong YUAN1, 2, Kun XIAO1
Affiliations
  • 1College of Water Resource & Hydropower, Sichuan University, Chengdu 610065, Sichuan, China
  • 2China Railway Eryuan Engineering Group Company, Ltd., Chengdu 610031, Sichuan, China
Published: 2025-02-28 doi: 10.12090/j.issn.1006-6616.2024065
Outline
收藏切换
Objective

With the relocation of major national strategic plans to western China, railway construction has gradually focused on the complex and dangerous mountainous regions of Yunnan, Sichuan, and Xizang Provinces, where the proportion of tunnels along the railway is very high. When a tunnel passes through a water-rich fault fracture zone, the rock mass in front of the palm face is prone to hydraulic fracturing and damage under high osmotic pressure, leading to disasters such as rock collapse and water inrush.

Methods

The wing crack model is introduced to fully account for the initiation and propagation of secondary wing cracks in water-saturated fractures, as well as the impact of excavation disturbances. The effective tensile stress and rock bridge size between intermittent fractures in the rock are revised. The tensile-shear failure mechanism of the water-insulating rock mass in front of the tunnel face is analyzed, and the critical water pressure for hydraulic fracturing of the water-insulating rock mass is derived. The minimum safety thickness for the tunnel face against water inrush in the proximity of a fault fracture zone is proposed.

Results

The theoretical formulas indicate that the anti-splitting thickness of the water-insulating rock mass is related to factors such as tunnel section size, fault water pressure, excavation disturbance, in-situ stress, rock mass strength, crack size, and fracture parameters. Through analysis of the sensitivity of the different influencing factors, it is found that the anti-splitting thickness of the rock mass increases with the increase of the tunnel section size, the fault water pressure, and the excavation disturbance factor, but decreases with the increase of the vertical tunnel stress and the rock mass strength. At the same time, the excavation disturbance damage has the most significant impact on the calculated anti-splitting thickness of the rock mass.

Conclusion

In practical engineering, there are certain empirical judgments and errors in obtaining excavation disturbance factors via rock integrity assessment and rock wave velocity testing. Therefore, this method requires accurate acquisition of the damage conditions of the rock mass in front of the tunnel face. Various assessment methods can be used for comparison and selection, and a conservative approach can be adopted by using a larger value for the excavation disturbance factor.

Significance

Finally, taking a tunnel in western Sichuan near the Yalahe fault as an example and considering the actual engineering disturbance and fault water pressure, the minimum safety thickness of the rock wall at the tunnel face is calculated to verify the engineering applicability of the proposed method. This research can effectively guide on-site risk prediction and plan formulation; it provides a theoretical basis for the prevention and control of water inrush in tunnels crossing water-rich fault fracture zones.

fault fracture zone  /  water inrush disaster  /  minimum safety thickness  /  wing crack model  /  rock mass mechanics  /  tunnel engineering
袁东, 肖坤. 隧道穿越断层破碎带突水机制及岩墙最小安全厚度研究. 地质力学学报, 2025 , 31 (1) : 80 -90 . DOI: 10.12090/j.issn.1006-6616.2024065
Dong YUAN, Kun XIAO. Water inrush mechanism and the minimum safety thickness of the rock wall of a tunnel crossing a fault fracture zone[J]. Journal of Geomechanics, 2025 , 31 (1) : 80 -90 . DOI: 10.12090/j.issn.1006-6616.2024065
  • This research is financially supported by the Key Research and Development Program of Xizang Autonomous Region (Grant No. XZ202201ZY0021G); the China Railway Group Limited Technology Research and Development Plan (Grants No. 2021-Major-01 and 2022-Major-01) and the Guided Project of China Railway Eryuan Engineering Group Co., Ltd (Grant No. KDNQ213043).
Year 2025 volume 31 Issue 1
179
90
Cite this Article
BibTeX
Article Info
doi: 10.12090/j.issn.1006-6616.2024065
  • Receive Date:2024-06-04
  • Online Date:2026-11-13
  • Published:2025-02-28
Article Data
Affiliations
History
  • Received:2024-06-04
  • Revised:2024-12-09
  • Accepted:2024-12-11
Funding
This research is financially supported by the Key Research and Development Program of Xizang Autonomous Region (Grant No. XZ202201ZY0021G); the China Railway Group Limited Technology Research and Development Plan (Grants No. 2021-Major-01 and 2022-Major-01) and the Guided Project of China Railway Eryuan Engineering Group Co., Ltd (Grant No. KDNQ213043).
Affiliations
    1College of Water Resource & Hydropower, Sichuan University, Chengdu 610065, Sichuan, China
    2China Railway Eryuan Engineering Group Company, Ltd., Chengdu 610031, Sichuan, China
References
Share
https://castjournals.cast.org.cn/joweb/dzlxxb/EN/10.12090/j.issn.1006-6616.2024065
Share to
QR

Scan QR to access full text

Cite this article
BibTeX
Citations
表12种不同金属材料的力学参数
科
Family
属数
Number of
genus
种数
Number of
species
占总种数比例
Percentage of
total species (%)
属
Genus
种数
Number of
species
占总种数比例
Percentage of total
species (%)
鹅膏菌科Amanitaceae 2 11 5.26 鹅膏菌属 Amanita 10 4.78
小菇科 Mycenaceae 2 12 5.74 丝盖伞属 Inocybe 5 2.39
多孔菌科 Polyporaceae 8 14 6.70 蜡蘑属 Laccaria 5 2.39
红菇科 Russulaceae 3 23 11.00 小皮伞属 Marasmius 6 2.87
小菇属 Mycena 11 5.26
光柄菇属 Pluteus 5 2.39
红菇属 Russula 17 8.13
栓菌属 Trametes 5 2.39
关闭全屏
  • BibTeX
  • EndNote
  • RefWorks
  • TxT