硅酸盐学报

耐辐射高铅玻璃熔制挥发物分析及控制

PDF下载

杨胜赟 ¹ , 曹振博 ¹^,² , 张梅伦 ¹ , 张洋 ¹^,² , 王可 ¹ , 韩玉 ¹ , 吕海风 ¹ , 周游 ¹^,² , 贾金升 ¹^,²

硅酸盐学报 | 研究论文 2024,52(7): 2364-2370

收起

硅酸盐学报 |研究论文 2024 , 52 (7) : 2364 -2370

耐辐射高铅玻璃熔制挥发物分析及控制

全屏

杨胜赟¹, 曹振博¹^,², 张梅伦¹, 张洋¹^,², 王可¹, 韩玉¹, 吕海风¹, 周游¹^,², 贾金升¹^,²

作者信息

^1．中建材光子科技有限公司，山东枣庄 277000

^2．中国建筑材料科学研究总院有限公司，北京 100000

通讯作者:

曹振博（1985—），男，博士，教授级高级工程师。

作者简介:

杨胜赟（1998—），男，硕士。

Analysis and Control of Volatile Matter in Radiation Resistant High Lead Glass Melting

Shengyun YANG¹, Zhenbo CAO¹^,², Meilun ZHANG¹, Yang ZHANG¹^,², Ke WANG¹, Yu HAN¹, Haifeng LV¹, You ZHOU¹^,², Jinsheng JIA¹^,²

Affiliations

^1.China National Building Material Photonics Technology Co., Ltd., Zaozhuang 277000, Shandong, China

^2.China Building Materials Academy Co., Ltd., Beijing 100000, China

Corresponding Author:

CAO Zhenbo (1985-), male, Ph.D., Professor. E-mail: czb824@163.com

YANG Shengyun (1998-), male, Master. E-mail: yang_yue98@163.com

出版时间: 2024-07-20 doi: 10.14062/j.issn.0454-5648.20230929

文章导航

摘要

收起

用于制备耐辐射光纤面板的高铅（铅当量≥0.3）玻璃材料须具备较高的折射率、较好的X射线吸收性能、较高的可见光透过率以及良好的热稳定性和化学稳定性。但由于其高铅含量对熔制坩埚及耐火材料腐蚀性极高，且熔制过程中挥发量较高，玻璃组分不易稳定控制，目前仅国外少数企业能够高质量稳定生产。研究了玻璃熔制过程中影响挥发物的3个主要因素，有效控制挥发物的挥发率由2.00%降至0.51%左右，确定了最佳熔制温度以及通气压强，并在此条件下分别采用2种方式向玻璃中引入铅，通过能谱仪和光电子能谱仪对该高铅玻璃在熔制过程中的挥发物进行了研究，确定了其挥发物成分以铅氧化物为主，其中铅的价态以四价为主，二价为辅。

关键词

耐辐射光纤面板 / 玻璃 / 熔制 / 挥发物

Abstract

收起

Introduction

Radiation resistant optical fiber panel is a kind of optical fiber material device with special functions. As a core component of X-ray radiology, this fiber material is widely used in digital X-ray imaging, pet medical treatment, security inspection, industrial nondestructive testing and food safety testing. The industry entry threshold for radiation resistant fiber optic panels is relatively high. The existing market of high lead glass materials for radiation-resistant optical fiber panel is basically monopolized. To ensure high visible light transmittance, good thermal stability, and chemical stability of glass materials used in radiation resistant fiber optic panels, a higher content of PbO is introduced into the glass composition to further improve its refractive index and X-ray absorption performance In this paper, the main factors (i.e., temperature, atmospheric pressure and raw material) affecting the volatilization of PbO in the melt of high-lead glass for radiation-resistant optical fiber panels were analyzed.

Materials and method

A yellow lead was selected as a raw material to introduce lead into the glass, and the experiments were carried out at different melting temperatures. The melting temperature was optimized based on the experimental results. The atmosphere pressure of crucible kiln changed to further control the volatilization of radiation-resistant glass in the melting process. Under the optimal process conditions, a more effective way to control volatiles was explored via changing the lead oxide introduction method. Also, the volatiles of the glass melt with different raw material introduction methods were determined by energy dispersive spectroscopy (EDS) and X-ray photoelectron spectroscopy (XPS), and the main components and contents of the volatiles were analyzed.

Results and discussion

In the mixed materials with the same lead oxide content, the glass in the melting process of volatile amount decreases, and the volatility rate decreases from 2.00% at 1 530 ℃ to 1.53% at 1 500 ℃ as the melting temperature decreases. In addition, when the melting temperature decreases < 1 500 ℃, hard-melt substances in the glass sample appear possibly due to the enrichment of CaO, LaO and PbO. At 1 500 ℃, the volatilizing amount of glass decreases with the increase of atmospheric pressure in crucible, and the volatilizing rate decreases from 1.53% at 0 MPa to 0.80% at 0.4 MPa. When the pressure of the gas further increases, it leads to massive stripes on the surface of the glass liquid, affecting the quality of the product. At the same lead oxide content in the mixing material, melting temperature and ventilation pressure, lead oxide is introduced into the glass by two approaches, i.e., lead is introduced into the glass with yellow lead as a raw material, and lead is introduced into the glass with red lead as a raw material. Based on the results of composition test and analysis of the glass material obtained by melting, the glass in the melting process of volatile amount decreases, and the volatility rate decreases from 0.80% to 0.51% when red lead is used to introduce lead into the glass. From the EDS spectra of volatile sample, lead oxide volatilizes in glass material during melting process. As yellow lead is used as a raw material to the glass introduction, the percentage of lead atoms in the volatiles is 35.44%. As red lead is used as a raw material, the percentage of lead atoms in the volatiles is 22.21%. The XPS spectra of volatile samples with two different lead introduction methods show that element lead is the main valence state, the valence state is auxiliary.

Conclusions

The influences of melting temperature, ventilation pressure and raw material introduction mode on the volatiles in the glass melting process were investigated. At the melting temperature of 1 500 ℃, the ventilation pressure of 0.4 MPa, and red lead as a raw material to introduce lead into the glass, the volatile amount of volatiles in the glass melting process was effectively controlled, and the volatility of lead oxide was reduced from 2.00% to 0.51%. At the melting temperature of 1 500 ℃ and ventilation pressure of 0.4 MPa, red lead or yellow lead as a raw material to introduce lead, the valence state of Pb element in the glass melting volatiles was mainly tetravalent, and the divalent was auxiliary. The content ratio of tetravalent lead and divalent lead was 4.79 and 4.94, respectively.

Key words

radiation resistant fiber optic panel / glass / melting / volatile matter

引用本文

杨胜赟, 曹振博, 张梅伦, 张洋, 王可, 韩玉, 吕海风, 周游, 贾金升. 耐辐射高铅玻璃熔制挥发物分析及控制. 硅酸盐学报, 2024 , 52 (7) : 2364 -2370 . DOI: 10.14062/j.issn.0454-5648.20230929

Shengyun YANG, Zhenbo CAO, Meilun ZHANG, Yang ZHANG, Ke WANG, Yu HAN, Haifeng LV, You ZHOU, Jinsheng JIA. Analysis and Control of Volatile Matter in Radiation Resistant High Lead Glass Melting[J]. Journal of the Chinese Ceramic Society, 2024 , 52 (7) : 2364 -2370 . DOI: 10.14062/j.issn.0454-5648.20230929

基金

收起

枣庄英才集聚工程专项
中建材光子科技有限公司技术开发项目(SJ-2022-GZ-53)
中国建材集团攻关专项(2021HX1516-04)

参考文献

收起

文献

收起

参考文献引证文献

排序方式：

2024年第52卷第7期

PDF下载

引用本文

BibTeX

文章信息

doi: 10.14062/j.issn.0454-5648.20230929

接收时间：2023-12-01
首发时间：2026-10-22
出版时间：2024-07-20

补充材料

相关文章

文章信息

作者

出版历史

收稿日期：2023-12-01
修回日期：2024-01-09

基金

枣庄英才集聚工程专项

中建材光子科技有限公司技术开发项目(SJ-2022-GZ-53)

中国建材集团攻关专项(2021HX1516-04)

作者信息

^1．中建材光子科技有限公司，山东枣庄 277000

^2．中国建筑材料科学研究总院有限公司，北京 100000

通讯作者:

曹振博（1985—），男，博士，教授级高级工程师。

参考文献

分享链接

https://castjournals.cast.org.cn/joweb/gsyxb/CN/10.14062/j.issn.0454-5648.20230929

分享至

全文二维码

扫描看全文

引用本文

BibTeX

本文的引用情况

2种不同金属材料的力学参数

科 Family	属数 Number of genus	种数 Number of species	占总种数比例 Percentage of total species (%)	属 Genus	种数 Number of species	占总种数比例 Percentage of total species (%)
鹅膏菌科Amanitaceae	2	11	5.26	鹅膏菌属 Amanita	10	4.78
小菇科 Mycenaceae	2	12	5.74	丝盖伞属 Inocybe	5	2.39
多孔菌科 Polyporaceae	8	14	6.70	蜡蘑属 Laccaria	5	2.39
红菇科 Russulaceae	3	23	11.00	小皮伞属 Marasmius	6	2.87
				小菇属 Mycena	11	5.26
				光柄菇属 Pluteus	5	2.39
				红菇属 Russula	17	8.13
				栓菌属 Trametes	5	2.39

关闭全屏

BibTeX
EndNote
RefWorks
TxT