硅酸盐学报

TiO₂/Ti₃C₂复合材料的制备及其室温氨气敏感行为

PDF下载

张彪 ¹ , 益恒 ¹ , 陈毕谣 ¹ , 刘泓宇 ¹ , 李学林 ¹^,² , 朱建锋 ¹ , 殷澍 ³ , 施佩 ¹

硅酸盐学报 | 研究论文 2025,53(9): 2718-2727

收起

硅酸盐学报 |研究论文 2025 , 53 (9) : 2718 -2727

TiO₂/Ti₃C₂复合材料的制备及其室温氨气敏感行为

全屏

张彪¹, 益恒¹, 陈毕谣¹, 刘泓宇¹, 李学林¹^,², 朱建锋¹, 殷澍³, 施佩¹

作者信息

^1．陕西科技大学材料科学与工程学院，陕西科技大学文物保护科学与技术学院，地下文物保护材料与技术教育部重点实验室，西安 710021，中国

^2．西部宝德科技股份有限公司，西安 710200，中国

^3．日本东北大学多元物质科学研究所，仙台 980-8577，日本

通讯作者:

施佩（1990—），女，博士，副教授。

作者简介:

张彪（1990—），男，博士，副教授。

Preparation and Ammonia Sensing Behavior of TiO₂/Ti₃C₂ Composites at Room Temperature

Biao ZHANG¹, Heng YI¹, Biyao CHEN¹, Hongyu LIU¹, Xuelin LI¹^,², Jianfeng ZHU¹, Shu YIN³, Pei SHI¹

Affiliations

^1.School of Material Science and Engineering, School of Conservation Science and Technology for Cultural Heritage, Key Laboratory of Underground Cultural Relics Conservation Materials and Technology, Ministry of Education, Shaanxi University of Science and Technology, Xi'an 710021, China

^2.Western Baode Technology Co., Ltd, Xi'an 710200, China

^3.Institute of Multidisciplinary Research for Advanced Materials (IMRAM), Tohoku University, Sendai 980-8577, Japan

Corresponding Author:

SHI Pei (1990-), female, Ph.D., associate Professor. E-mail: shipei7121@163.com

ZHANG Biao (1990-), male, Ph.D., Associate Professor. E-mail: zhangbiao@sust.edu.cn

出版时间: 2025-09-20 doi: 10.14062/j.issn.0454-5648.20250019

文章导航

摘要

收起

以MXene-Ti₃C₂和钛酸丁酯为原料，通过水热法在不同水热温度下制备出TiO₂/Ti₃C₂复合材料。采用X射线衍射、扫描电子显微镜、氮气吸附脱附、Raman光谱等对制备出的TiO₂/Ti₃C₂复合材料进行了结构和形貌表征。对TiO₂/Ti₃C₂复合材料进行了室温氨气敏感性能研究。结果表明：复合材料相较于纯相TiO₂纳米颗粒和Ti₃C₂具有更加优异的响应性，150 ℃水热得到的复合材料（样品TiO₂/Ti₃O₂-150），TiO₂颗粒负载较均匀且团聚现象较弱，比表面积较高，孔径较小，相较于180 ℃和210 ℃的样品响应值更高；当氨气浓度为300 μL/L时，样品TiO₂/Ti₃O₂-150气敏响应值达到34.77，相比于纯相TiO₂响应值提升了7倍以上，响应时间也由43 s缩短到了28 s，恢复时间由49 s缩短为37 s。此外，该样品在5种气体中表现出对氨气极高的选择性，且具有长期的响应稳定性。复合材料较纯相TiO₂具有更优异的气敏性能：一方面归因于Ti₃C₂的负载提升了复合材料的电子传输速率；另一方面两者复合产生的异质结界面势垒增大了气敏响应过程的电阻变化，从而使得气敏响应更加灵敏。

关键词

二氧化钛 / 碳化钛 / 水热法 / 气体传感器

Abstract

收起

Introduction

Ammonia is a toxic and harmful gas that affects the environment and human health. It is thus of great significance to identify and detect ammonia and its concentration rapidly and accurately for human health monitoring and ecological environment management. TiO₂ is widely used in the field of gas sensors due to its advantages of good stability, environmental tolerance, non-pollution, and outstanding contact reaction properties. However, it is gradually found that it has the disadvantages of long response/recovery time and low response value. MXene has a great potential in the field of gas sensing because of its large specific surface area and superior electron mobility rate, but its response value is rather low. In this work, TiO₂/Ti₃C₂ composites were prepared by an one-step hydrothermal method. The synergistic effect of semiconductor properties of TiO₂ and excellent electron transport performance of Ti₃C₂ was analyzed.

Methods

TiO₂/Ti₃C₂ composites at different hydrothermal temperatures were prepared by a hydrothermal method with MXene-Ti₃C₂ and butyl titanate as raw materials. The physical phase, surface morphology, specific surface area and pore size distribution, and structure of the samples were analyzed by X-ray diffraction (XRD), scanning electron microscopy (SEM), surface area measurement based on BET, and Raman spectroscopy. In addition, the ammonia sensing properties of TiO₂/Ti₃C₂ composites at room temperature were also analyzed.

Results and discussion

TiO₂/Ti₃C₂ composites can be prepared by a hydrothermal method. The XRD patterns indicate that the characteristic peaks of Ti₃C₂ and the diffraction peaks of anatase TiO₂ both appear in the composites. The Raman spectra show the generation of anatase TiO₂. The SEM images indicate that TiO₂ nanoparticles are uniformly loaded on the interlayer and surface of Ti₃C₂. The agglomeration of TiO₂ particles becomes more severe with the increase of hydrothermal temperature. The N₂ adsorption-desorption experiment shows that the specific surface area of prepared TiO₂/Ti₃C₂ is much larger than that of Ti₃C₂. Moreover, the specific surface area of TiO₂/Ti₃C₂-150 is the largest, but it gradually decreases with the increase of hydrothermal temperature possibly due to the agglomeration of the generated TiO₂ particles. The gas sensing test results show that TiO₂/Ti₃C₂ composites and pure TiO₂ have responses to 100 μL/L ammonia at room temperature, while Ti₃C₂ has little response. The response values of TiO₂/Ti₃C₂ composites are significantly better than that of pure TiO₂ obtained at the same temperature. Among all the samples, TiO₂/Ti₃C₂-150 has the maximum response value (i.e., 8.37). Also, the response value of the composites increases with the increase of ammonia concentration, showing a high linear correlation. After the stability test for one month, the response value of TiO₂/Ti₃C₂-150 to 100 μL/L ammonia is only decreased by 14.1%, indicating a long-term stability. Compared to TiO₂-150, the response time of TiO₂/Ti₃C₂-150 decreases from 43 s to 28 s, and the recovery time reduces from 49 s to 37 s, manifesting a high selectivity to ammonia. The stable gas absorption/desorption reaction of TiO₂ and thesuperior electron transport rate of Ti₃C₂ can enhance the response of TiO₂/Ti₃C₂ to ammonia.

Conclusions

The nanoparticles of anatase TiO₂ were supported on the interlayer and surface of Ti₃C₂ by a hydrothermal method. At the hydrothermal temperature of 150 ℃, TiO₂ particles were supported evenly and agglomerated weakly, with a greater specific surface area and smaller particle size. Compared to pure TiO₂ and Ti₃C₂, TiO₂/Ti₃C₂-150 had a good response to ammonia at room temperature. At an ammonia concentration of 300 μL/L, the gas sensing response value of TiO₂/Ti₃C₂-150 was 34.77, which was greater than that of pure TiO₂. In addition, TiO₂/Ti₃C₂-150 also showed a rapid response recovery rate, a good selectivity and a long-term response stability, having a promising application prospect in the field of rapid detection of ammonia at room temperature.

Key words

titanium dioxide / titanium carbide / hydrothermal method / gas sensor

引用本文

张彪, 益恒, 陈毕谣, 刘泓宇, 李学林, 朱建锋, 殷澍, 施佩. TiO₂/Ti₃C₂复合材料的制备及其室温氨气敏感行为. 硅酸盐学报, 2025 , 53 (9) : 2718 -2727 . DOI: 10.14062/j.issn.0454-5648.20250019

Biao ZHANG, Heng YI, Biyao CHEN, Hongyu LIU, Xuelin LI, Jianfeng ZHU, Shu YIN, Pei SHI. Preparation and Ammonia Sensing Behavior of TiO₂/Ti₃C₂ Composites at Room Temperature[J]. Journal of the Chinese Ceramic Society, 2025 , 53 (9) : 2718 -2727 . DOI: 10.14062/j.issn.0454-5648.20250019

基金

收起

国家自然科学基金(52102108; 52102026)
中国博士后科学基金面上资助项目(2021M691997)
陕西省外国专家服务计划项目(2024WZ-YBXM-17)

参考文献

收起

文献

收起

参考文献引证文献

排序方式：

2025年第53卷第9期

PDF下载

引用本文

BibTeX

文章信息

doi: 10.14062/j.issn.0454-5648.20250019

接收时间：2025-01-10
首发时间：2026-10-21
出版时间：2025-09-20

补充材料

相关文章

文章信息

作者

出版历史

收稿日期：2025-01-10
修回日期：2025-02-14

基金

国家自然科学基金(52102108; 52102026)

中国博士后科学基金面上资助项目(2021M691997)

陕西省外国专家服务计划项目(2024WZ-YBXM-17)

作者信息

^1．陕西科技大学材料科学与工程学院，陕西科技大学文物保护科学与技术学院，地下文物保护材料与技术教育部重点实验室，西安 710021，中国

^2．西部宝德科技股份有限公司，西安 710200，中国

^3．日本东北大学多元物质科学研究所，仙台 980-8577，日本

通讯作者:

施佩（1990—），女，博士，副教授。

参考文献

分享链接

https://castjournals.cast.org.cn/joweb/gsyxb/CN/10.14062/j.issn.0454-5648.20250019

分享至

全文二维码

扫描看全文

引用本文

BibTeX

本文的引用情况

2种不同金属材料的力学参数

科 Family	属数 Number of genus	种数 Number of species	占总种数比例 Percentage of total species (%)	属 Genus	种数 Number of species	占总种数比例 Percentage of total species (%)
鹅膏菌科Amanitaceae	2	11	5.26	鹅膏菌属 Amanita	10	4.78
小菇科 Mycenaceae	2	12	5.74	丝盖伞属 Inocybe	5	2.39
多孔菌科 Polyporaceae	8	14	6.70	蜡蘑属 Laccaria	5	2.39
红菇科 Russulaceae	3	23	11.00	小皮伞属 Marasmius	6	2.87
				小菇属 Mycena	11	5.26
				光柄菇属 Pluteus	5	2.39
				红菇属 Russula	17	8.13
				栓菌属 Trametes	5	2.39

关闭全屏

BibTeX
EndNote
RefWorks
TxT