硅酸盐学报

大尺寸蒙脱石纳米片渗透水化剥离及调控机制

PDF下载

赵云良 ¹^,² , 王梳桐 ¹ , 陈立才 ¹ , 高仁波 ¹ , 张婷婷 ³ , 解蕾 ¹ , 宋少先 ¹

硅酸盐学报 | 环境矿物材料专题—研究论文 2024,52(10): 3131-3141

收起

硅酸盐学报 |环境矿物材料专题—研究论文 2024 , 52 (10) : 3131 -3141

大尺寸蒙脱石纳米片渗透水化剥离及调控机制

全屏

赵云良¹^,², 王梳桐¹, 陈立才¹, 高仁波¹, 张婷婷³, 解蕾¹, 宋少先¹

作者信息

^1．武汉理工大学资源与环境工程学院，武汉 430070

^2．硅酸盐建筑材料国家重点实验室（武汉理工大学），武汉 430070

^3．武汉轻工大学化学与环境工程学院，武汉 430023

通讯作者:

陈立才（1996—），男，博士。

作者简介:

赵云良（1987—），男，博士，教授。

Exfoliation and Preparation of Montmorillonite Nanosheets with Large Size Based on Osmotic Hydration

Yunliang ZHAO¹^,², Shutong WANG¹, Licai CHEN¹, Renbo GAO¹, Tingting ZHANG³, Lei XIE¹, Shaoxian SONG¹

Affiliations

^1.School of Resources and Environmental Engineering, Wuhan University of Technology, Wuhan 430070, China

^2.State Key Laboratory of Silicate Materials for Architectures, Wuhan University of Technology, Wuhan 430070, China

^3.School of Chemical and Environmental Engineering, Wuhan Polytechnic University, Wuhan 430023, China

Corresponding Author:

CHEN Licai (1996-), male, Ph.D. E-mail: chenlc1219@whut.edu.cn

ZHAO Yunliang (1987-), male, Ph.D., Professor. E-mail: zyl286@whut.edu.cn

出版时间: 2024-10-20 doi: 10.14062/j.issn.0454-5648.20240146

文章导航

摘要

收起

大尺寸的蒙脱石纳米片对于制备二维蒙脱石功能复合材料具有重要意义。采用原子力显微镜、透射电子显微镜和X射线衍射仪等方法研究了蒙脱石在渗透水化过程中的剥离行为，通过电导率分析和分子动力学模拟揭示了渗透水化剥离蒙脱石的机理，蒙脱石的剥片主要是在层间阳离子与外界水之间的渗透压作用下发生，进一步揭示了蒙脱石渗透水化过程中透析水量和悬浮液质量分数调控二维剥离的作用机制。结果表明：在渗透水化过程中，蒙脱石的片层厚度逐渐减小，但其片径尺寸并未遭到严重破坏，从而成功制备了大尺寸的二维蒙脱石纳米片。渗透水化制备的二维蒙脱石的厚度可达到超声剥离的效果，片径尺寸约为超声剥离的2倍以上。

关键词

蒙脱石 / 渗透水化 / 剥离 / 大尺寸 / 二维纳米片

Abstract

收起

Introduction

Montmorillonite (MMT) nanosheets with large sizes is significant for controllable preparation of MMT functional nanocomposite materials. Compared with MMT, two-dimensional MMT nanosheets have a larger specific surface area, higher aspect ratio and richer hydroxyl groups at the edges. Therefore, MMT nanosheets are widely applied in the fields like environmental remediation, energy storage, flame retardant and membrane materials. The methods for preparing two-dimensional MMT nanosheets include mechanical milling, shearing, intercalation and ultrasonic exfoliation. However, the size of MMT nanosheets can be seriously damaged because of the higher external energy input of these exfoliation methods, thus affecting the applications. It is thus necessary to propose a new method for preparing MMT nanosheets with large sizes. In this paper, a method of MMT exfoliation was investigated based on its nature of osmotic hydration through weakening the interlayer binding energy of MMT. The exfoliation mechanism of MMT based on osmotic hydration was revealed via the conductivity analysis and molecular simulation. In addition, the regulation mechanism of exfoliation was also explored through the regulation of the water consumption and the concentration of MMT suspension during the osmotic hydration.

Methods

Sodium-exchanged MMT suspensions were stirred and dispersed. One end of a dialysis bag (a molecular weight cutoff of 3 000 Da) was sealed using a clamp. Subsequently, 100 mL of the suspensions was transferred into the dialysis bag, followed by sealing the other end with another clamp. Afterwards, the dialysis bag was placed in a beaker containing 500 mL of deionized water. The suspensions in the beaker was stirred in a magnetic stirrer at 200 r/min. Within the initial 12 h, the water in the beaker was refreshed every 3 h by pouring it out and replacing it with fresh deionized water. At 24 h and 36 h, the deionized water was replaced once again. At different time intervals, 2 mL samples were extracted from the dialysis bag using a pipette for subsequent test and analysis. These samples were labeled as MMT-t (where "t" represents the osmotic hydration time). The thickness of different two-dimensional MMT nanosheets was characterized by a model Multi Mode 8 atomic force microscope and a model JEM-F200 transmission electron microscope. Besides, the morphology of the two-dimensional MMT was determined by a model JSM 7100F scanning electron microscope.

Results and discussion

MMT can be exfoliated into two-dimensional nanosheets during the osmotic hydration. The exfoliation degree of montmorillonite gradually increases with extending the osmotic hydration time to 48 h, which can achieve the thickness of MMT nanosheets similar to that of ultrasonic exfoliation. From the particle size distribution of MMT with dialysis time, the size distribution of MMT-48 is 48% in 0-300 nm and 30% in 300-600 nm, respectively. However, the size of MMT nanosheets using the same raw MMT material prepared by the ultrasonic exfoliation was distributed in the range of 100-300 nm. Therefore, the sizes of two-dimensional MMT nanosheets prepared by the osmotic hydration have more than twice greater than those by the ultrasonic exfoliation, demonstrating the effective preparation of two-dimensional MMT nanosheets with large sizes.

Furthermore, the exfoliation behavior of MMT through the osmotic hydration was investigated. The XRD patterns show that the a plane (001) of MMT appears a broad dispersion when the osmotic hydration time extends to 24 h, indicating that the laminar structure of MMT is destroyed and the exfoliation degree of MMT is increased. As the osmotic hydration time is 36 h or 48 h, the diffraction peaks corresponding to the crystal plane (001) of MMT disappear, exhibiting the emergence of an amorphous diffraction peak. This demonstrated that MMT is effectively exfoliated into nanosheets with a single layer or a few layers. The XRD patterns confirm that the exfoliation of MMT based on the osmotic hydration is achieved via promoting the hydration expansion. In addition, the exfoliation process is relatively slow and gentle, greatly protecting the size of MMT. There is osmotic pressure between MMT and the deionized water because of the concentration gradient between the interlayer cations of MMT and the deionized water in the surrounding environment. In osmotic pressure, more water molecules can penetrate into the interlayer of MMT, thereby promoting a further hydration exfoliation of MMT. The size of montmorillonite cannot be seriously damaged due to the increased hydration expansion force and low external input energy, resulting in the easier preparation of MMT nanosheets with large-sizes.

Conclusions

The thickness of MMT gradually decreased, but the size of MMT was barely damaged during the osmotic hydration, resulting in the effective preparation of two-dimensional MMT nanosheets with large sizes. The conductivity analysis and molecular simulation indicated that the exfoliation of MMT was controlled by the osmotic pressure between the interlayer cations and the external water. The exfoliation degree of MMT could be controllable with the water consumption and suspension concentration. The two-dimensional MMT nanosheets prepared by osmotic hydration had a thickness similar to that by ultrasonic exfoliation, and the size of MMT nanosheets prepared by osmotic hydration was twice greater than that by ultrasonic exfoliation.

Key words

montmorillonite / osmotic hydration / exfoliation / large size / two-dimensional nanosheets

引用本文

赵云良, 王梳桐, 陈立才, 高仁波, 张婷婷, 解蕾, 宋少先. 大尺寸蒙脱石纳米片渗透水化剥离及调控机制. 硅酸盐学报, 2024 , 52 (10) : 3131 -3141 . DOI: 10.14062/j.issn.0454-5648.20240146

Yunliang ZHAO, Shutong WANG, Licai CHEN, Renbo GAO, Tingting ZHANG, Lei XIE, Shaoxian SONG. Exfoliation and Preparation of Montmorillonite Nanosheets with Large Size Based on Osmotic Hydration[J]. Journal of the Chinese Ceramic Society, 2024 , 52 (10) : 3131 -3141 . DOI: 10.14062/j.issn.0454-5648.20240146

基金

收起

国家重点研发计划青年科学家项目(2022YFC2906300)
国家自然科学基金面上项目(52374275)
湖北省自然科学基金杰出青年项目(2023AFA084)

参考文献

收起

文献

收起

参考文献引证文献

排序方式：

2024年第52卷第10期

PDF下载

引用本文

BibTeX

文章信息

doi: 10.14062/j.issn.0454-5648.20240146

接收时间：2024-02-26
首发时间：2026-10-22
出版时间：2024-10-20

补充材料

相关文章

文章信息

作者

出版历史

收稿日期：2024-02-26
修回日期：2024-03-19

基金

国家重点研发计划青年科学家项目(2022YFC2906300)

国家自然科学基金面上项目(52374275)

湖北省自然科学基金杰出青年项目(2023AFA084)

作者信息

^1．武汉理工大学资源与环境工程学院，武汉 430070

^2．硅酸盐建筑材料国家重点实验室（武汉理工大学），武汉 430070

^3．武汉轻工大学化学与环境工程学院，武汉 430023

通讯作者:

陈立才（1996—），男，博士。

参考文献

分享链接

https://castjournals.cast.org.cn/joweb/gsyxb/CN/10.14062/j.issn.0454-5648.20240146

分享至

全文二维码

扫描看全文

引用本文

BibTeX

本文的引用情况

2种不同金属材料的力学参数

科 Family	属数 Number of genus	种数 Number of species	占总种数比例 Percentage of total species (%)	属 Genus	种数 Number of species	占总种数比例 Percentage of total species (%)
鹅膏菌科Amanitaceae	2	11	5.26	鹅膏菌属 Amanita	10	4.78
小菇科 Mycenaceae	2	12	5.74	丝盖伞属 Inocybe	5	2.39
多孔菌科 Polyporaceae	8	14	6.70	蜡蘑属 Laccaria	5	2.39
红菇科 Russulaceae	3	23	11.00	小皮伞属 Marasmius	6	2.87
				小菇属 Mycena	11	5.26
				光柄菇属 Pluteus	5	2.39
				红菇属 Russula	17	8.13
				栓菌属 Trametes	5	2.39

关闭全屏

BibTeX
EndNote
RefWorks
TxT